Skip to content
Burnaby Masonry Co.Masonry Contractor
Chimney Repair & Rebuilding in Vancouver, BC

Chimney Repair & Rebuilding in Vancouver, BC

Leaning, leaking, or crumbling chimneys repaired, rebuilt above the roofline, or fully reconstructed. Serving Vancouver and Metro Vancouver — free quotes.

Burnaby Masonry Co. provides expert chimney repair & rebuilding in Vancouver, BC. Leaning, leaking, or crumbling chimneys repaired, rebuilt above the roofline, or fully reconstructed. Call us for a free quote — we're based in Burnaby and serve Vancouver regularly.

Chimney Repair & Rebuilding in Vancouver: what to know

Vancouver's older East Side is full of soft brick chimneys from the early 1900s. Crown failures, spalling brick, and failed mortar are common, and heritage-sensitive repair is essential on this stock — not modern hard Portland mortar.

Chimney repair and rebuilding covers everything from a leaking crown to a chimney that's leaning and needs to come down to the roofline and be rebuilt. Chimneys take the worst of the weather, so they fail before the rest of the house. We diagnose the real problem, whether it's a cracked crown, failed flashing, spalling brick, or a deeper structural issue, and fix it properly. In the Lower Mainland's wet climate, a sound chimney is mostly about keeping water out, and that's exactly what we build for.

What's included in our chimney repair & rebuilding service

  • Full chimney inspection from the firebox to the crown
  • Crown repair or rebuild to stop water sitting on top
  • Repointing failed mortar joints in the stack
  • Brick replacement for spalled or cracked masonry
  • Rebuilds above the roofline where the damage stops
  • Full chimney reconstruction when the structure is gone
  • New chimney caps and flashing detail to seal the penetration
  • Water-repellent sealing on the finished masonry

When Vancouver homeowners call us for chimney repair & rebuilding

The chimney is leaning or bowing

This is a safety issue. Leaning masonry means the structure or footing is failing and it can fall. Stop using it and call us.

Water stains on the ceiling near the chimney

A leaking chimney shows up as stains inside before you ever see it outside. The crown, cap, or flashing is usually the culprit.

Crumbling brick or mortar on the stack

Pieces of brick or mortar in the gutter or on the roof mean freeze-thaw is breaking the chimney apart.

A cracked or missing crown

The crown is the concrete cap on top. When it cracks, water pours straight into the chimney and accelerates everything.

Vancouver properties: what we see

Vancouver has the widest range of masonry in BC. The East Side — Strathcona, Grandview-Woodland, Mount Pleasant, Commercial Drive — is dense with pre-1940 wood-frame homes built with soft lime-mortar brick chimneys, and the original brick on many of them has never been touched since it was laid. The West Side runs toward post-war concrete block and newer stone veneer on high-end renovations. Kitsilano has a large number of heritage character homes where sympathetic repair is the brief. Point Grey and Shaughnessy have custom homes where the standard for stone and brick work is higher than almost anywhere else in the region.

We work throughout Vancouver — including Strathcona, Kitsilano, Mount Pleasant, Commercial Drive — and we know how the terrain, housing stock, and climate vary across the city. Every quote reflects what we actually see on site.

Chimney Repair & Rebuilding in Vancouver, BC

How we do chimney repair & rebuilding in Vancouver

  1. 1

    Inspect top to bottom

    We check the crown, cap, flashing, mortar, and brick, and look for any structural movement, then tell you what's actually wrong.

  2. 2

    Recommend repair or rebuild

    Small problems get repaired. If the damage runs deep, we rebuild from the point where the masonry is still sound.

  3. 3

    Do the masonry

    We repoint, replace brick, or rebuild the stack with matching materials and a properly formed crown that sheds water.

  4. 4

    Seal the penetration

    New flashing and a quality cap keep water out where the chimney meets the roof, which is where most leaks start.

  5. 5

    Waterproof and finish

    We apply a breathable water repellent so the masonry stays dry through our wet winters, then clean up the roof and site.

Why choose Burnaby Masonry for chimney repair & rebuilding in Vancouver

We find the real leak

Most chimney leaks are misdiagnosed. We trace it to the source instead of slapping sealant on and hoping.

Built for Lower Mainland weather

Our crowns, caps, and flashing are detailed for heavy, sideways rain, not a dry climate.

Safe with structural calls

If a chimney is unsafe, we'll tell you plainly and won't push a band-aid fix on something that needs a rebuild.

Clean, careful roof work

We protect your roof and property and leave the site clean. No debris left in the gutters.

More masonry services in Vancouver

Chimney Repair & Rebuilding across Metro Vancouver

Chimney Repair & Rebuilding in Vancouver: FAQs

Do you do chimney repair & rebuilding in Vancouver?

Yes. Burnaby Masonry Co. covers Vancouver and all of Metro Vancouver for chimney repair & rebuilding. Vancouver's older East Side homes (many built before 1940) often have soft lime mortar joints that need careful repointing rather than hard modern mortar.

Do you repoint heritage brick in East Vancouver?

Yes — and we do it correctly. Pre-1940 brick in Strathcona, Mount Pleasant, and Grandview-Woodland was laid with soft lime mortar. We repoint with a matching lime-based mix. Using hard Portland on these walls causes the brick faces to spall within a few winters — it's the most common damage we're called to fix after a bad repair.

Can you match old brick for a repair in Vancouver?

In most cases, yes. We source reclaimed Clayburn brick and other period-appropriate salvage to match the colour, texture, and size of original East Van brick. An exact match is sometimes impossible, but a close match in the right mortar is usually invisible from the street.

My chimney is leaning. Is that dangerous?

A leaning chimney means the masonry or footing is failing, and it can come down in a windstorm. Stop using it and call us. We'll tell you whether it can be repaired or needs a rebuild above the roofline.

Why is my chimney leaking when it rains?

Usually it's a failed crown, missing cap, or cracked mortar joints letting water in. We find the source and fix it, then seal the masonry so it stays dry.

Get a free chimney repair & rebuilding quote in Vancouver

Burnaby Masonry Co. offers free, no-obligation quotes on brick, stone, and block projects in Burnaby and across Metro Vancouver.

Call (604) 210-5842