Skip to content
Burnaby Masonry Co.Masonry Contractor
Brick Repair & Repointing in Port Moody, BC

Brick Repair & Repointing in Port Moody, BC

Crumbling mortar joints raked out and repointed, cracked and spalled brick replaced to match. Serving Port Moody and Metro Vancouver — free quotes.

Burnaby Masonry Co. provides expert brick repair & repointing in Port Moody, BC. Crumbling mortar joints raked out and repointed, cracked and spalled brick replaced to match. Call us for a free quote — we're based in Burnaby and serve Port Moody regularly.

Brick Repair & Repointing in Port Moody: what to know

Port Moody's inlet-adjacent homes and Heritage Mountain's sloped properties both see mortar damage from moisture and freeze-thaw cycles. We repoint chimney stacks, foundations, and garden walls across the city.

Brick repair and repointing fixes the part of your wall that actually fails first: the mortar. When the joints between bricks crumble, water gets behind the wall and the damage spreads fast. We rake out the old, failing mortar, replace any cracked or spalled brick to match, and repoint with the right mortar mix so the wall sheds water again. It's the single most cost-effective thing you can do to add decades to a brick wall, chimney, or foundation in Burnaby.

What's included in our brick repair & repointing service

  • Inspection of every joint to find where the mortar has failed
  • Raking out old, loose, or cracked mortar to the proper depth
  • Mortar matched to your wall's colour, texture, and joint profile
  • Soft lime mortar on older homes so we don't crack original brick
  • Replacement of cracked, spalled, or missing brick to match
  • Repointing chimneys, foundations, garden walls, and facades
  • Cleaning the finished wall and protecting landscaping below
  • A walk-through when we're done so you can see the work up close

When Port Moody homeowners call us for brick repair & repointing

Crumbling or recessed mortar joints

If you can scratch the mortar out with a key or see it powdering at the base of the wall, the joints have failed and water is getting in.

Cracked or flaking brick (spalling)

Brick faces popping off usually means trapped moisture and freeze-thaw. The brick and the joints around it both need attention.

A damp or musty interior wall

Failed exterior joints are a common source of moisture inside the home, especially on older Vancouver and New West houses.

Visible gaps or daylight through joints

Any gap is an open door for water. Caught early, repointing is simple. Left alone, it turns into a rebuild.

Port Moody properties: what we see

Port Moody is a smaller city with a distinct character driven by its inlet setting and a mix of Heritage Mountain's newer sloped subdivisions and the older Ioco Road and Murray Street neighbourhoods near the water. Suter Brook and Newport Village are the dense newer residential areas, while Heritage Mountain has larger homes on steep lots that regularly need retaining wall work. Rocky Point Park gives the city its outdoor character, and many homes near the inlet incorporate outdoor living spaces — fireplaces, patios, stone walls — that tie to the waterfront setting.

We work throughout Port Moody — including Suter Brook, Newport Village, Heritage Mountain, Rocky Point — and we know how the terrain, housing stock, and climate vary across the city. Every quote reflects what we actually see on site.

Brick Repair & Repointing in Port Moody, BC

How we do brick repair & repointing in Port Moody

  1. 1

    Assess the mortar and brick

    We check joint depth, mortar hardness, and brick condition, then tell you straight whether you need a small repair or a larger section done.

  2. 2

    Match the mortar

    We mix to match the colour, sand, and strength of the original. On pre-1940 homes that means lime-based mortar, not hard modern Portland mix.

  3. 3

    Rake and repoint

    Old mortar comes out to the correct depth, joints get cleaned, and fresh mortar is packed in and tooled to match the original profile.

  4. 4

    Replace damaged brick

    Cracked or spalled brick is cut out and replaced with a match, blended so the repair disappears into the wall.

  5. 5

    Clean and protect

    We clean the face, clear the site, and let you inspect the finished joints before we pack up.

Why choose Burnaby Masonry for brick repair & repointing in Port Moody

We match, we don't smear

A lot of repointing jobs look worse than the problem because the mortar doesn't match. We get colour and joint profile right.

Right mortar for the age of the home

Using hard mortar on soft old brick cracks the brick. We pick the mix based on what your wall is built from.

Local crews who know Burnaby brick

We work on these walls every week, from East Van character homes to Burnaby post-war bungalows.

Honest about scope

If a patch will do, we'll say so. If it needs more, we'll show you why before any work starts.

More masonry services in Port Moody

Brick Repair & Repointing across Metro Vancouver

Brick Repair & Repointing in Port Moody: FAQs

Do you do brick repair & repointing in Port Moody?

Yes. Burnaby Masonry Co. covers Port Moody and all of Metro Vancouver for brick repair & repointing. A lot of Heritage Mountain homes sit on slopes, so patios and outdoor living spaces usually pair with a small retaining wall.

Can you build an outdoor fireplace in Port Moody?

Yes — outdoor fireplaces and fire features are regular work for us on Port Moody properties. We build masonry fireboxes with proper clearances, flue design, and foundations that hold up through our wet winters. We advise on permit requirements before starting.

My Heritage Mountain retaining wall is starting to lean. What should I do?

A leaning retaining wall usually means the drainage behind it is failing. Don't wait — the lean will accelerate. We assess the wall, determine whether repair or replacement is needed, and give you a written quote. Walls over 1.2m will need a permit.

How do I know if my brick needs repointing?

Look at the mortar joints. If you can scratch them out with a key, see gaps, or notice mortar dust at the base of the wall, the joints are failing and the brick needs repointing before water gets behind it.

Can you match the mortar on my older home?

We match colour, joint profile, and mortar type. On pre-1940 homes that usually means a softer lime-based mortar, not the hard modern stuff that cracks old brick.

Get a free brick repair & repointing quote in Port Moody

Burnaby Masonry Co. offers free, no-obligation quotes on brick, stone, and block projects in Burnaby and across Metro Vancouver.

Call (604) 210-5842